|
|
|
|
|
|
||||||
 |
 |
 |
 |
 |
 |
 |
| K.I.S.S. Kiln Interface Software System KISS is a full featured computer software program that allows you to program, monitor, collect firing data and start/stop your kiln using your PC!! KISS can control and monitor up to 10 kilns equipped with the RampMaster 2 controller. Installation is simple: connect the harness to the RampMaster 2 control board and any available PC COM port, install the software and you're ready to go. |
|
Main
Window - Displays the status of all connected kilns. Just click on a
kiln to check its status. |
|
|
|
|
|
Kiln Status
Window - Displays and controls all sorts of "need to know stuff" like
current temperatures, status of firing, current set point and segment,
current program, hold times, etc...... Definitely the most used screen of
the KISS program. |
|
|
|
|
|
Programming
Window - Develop your personal firing profiles in the Programming
Window or choose among a list of pre-set programs. |
|
|
|
|
| What's Needed? - To begin
with you will need the The KISS Starter Kit (SM-1). This kit includes all
the necessary hardware and software to get you going. Installation is very
easy. No really, it is! If you have more than one kiln you simply need the
KISS Kiln Kit (KM-1) to connect the remaining kilns. To say it another
way, the KISS Starter Kit (SM-1) is designed to connect the first, initial
kiln to your personal computer. In order to connect additional kilns, up
to 9 more, use the KISS Kiln Kit (KM-1).
Windows 95,
98, NT, 3.51 or later Equipment Requirements: The
KISS software/hardware packages are designed
|
